Table of Contents
Advertisement
Email service setting. By using this function in association with the Motion alarm function, the camera can sent the images
acquired by email on the Internet by contacting the set email server (SMTP).
Email: Disable/Enable.
SSL: Disable/Enable.
SMTP Server: Enter the email server address.
Sender Pwd: The sender's email password.
Snap Interval: This is the email sending
frequency in case of event.
5)
DDNS
Click on 【Network】) →【DDNS】 to access the following interface.
DDNS: This refers to the Dynamic Domain Name Server, which can be used to reach the camera via the Internet in
case of connection using a dynamic public IP address.
DS1099-077
SMTP Port: The default value is 25 (email service port). If
SSL is enabled, the port is usually 465.
Authentication: Disable/Enable.
Sender Email: The sender's email address.
Receiver Email: The recipient's email address (three
addresses are possible).
Test Email: This sends a email to test that parameter are
correct.
17
Advertisement
Table of Contents
