Table of Contents
Advertisement
Privacy and Copyright
➢
The IP camera is a CCTV system device. Recording of imagines is subject to the laws in force in your country.
Recording of images protected by copyright is forbidden.
➢
Product users shall be responsible for checking and respecting all local rules and regulations concerning monitoring
and recording video signals. The manufacturer SHALL NOT BE LIABLE for use of this product not in compliance with
the laws in force. For more information see http://www.garanteprivacy.it.
Firmware upgrades
➢
Periodically check the URMET Customer Service Technical Area for firmware upgrades.
Network configuration
➢
The camera is set to DHCP mode. If the network on which it is installed does not support dynamic addresses (DHCP),
the camera will automatically activate the default IP address 192.168.100.100. The "Easy Tool" Urmet software can
be used to change the default IP address and other network configurations of the camera to prevent conflicts with
other devices on the network. Always check the warnings for restrictions concerning the address which can be
assigned to the camera.
Network connections
When connecting a PC (using Software Client or Browser), any video channel on the PC will be using "unicast" connection
➢
(TCP, RTP, UDP).
➢
The device can support a limited number of "unicast" connections so it is possible to show the video on maximum 4 remote
devices (of which 2 smartphones at the most) at the same time depending on the available network band.
Reset button
The camera is equipped with two Reset buttons:
Button on the cable (press for at least 3 seconds): this can be used to reset all the factory settings of the IP
➢
camera only (e.g. camera password, video stream, image settings, motion detection, recording, etc.). It
leaves the WiFi and 4G configurations unchanged.
➢
Button adjacent to the nano-SIM slot: this can be used to restore all factory settings for the integrated 4G/WiFi router only.
It leaves the IP camera configurations unchanged
2
SIMPLIFIED EU DECLARATION OF CONFORMITY
Hereby, URMET S.p.A. declares that the radio equipment types: camera 1099/212, is in compliance with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the following internet address: www.urmet.com
3
INSTALLATION
1099/212 → WIFI BULLET VARIFOCAL CAMERA
3.1
It is advisable to proceed as follows for correct camera installation and configuration:
1.
Make sure that the unit to be connected is not powered before starting the installation procedure. Fit each of the
two aerials (black aerial for 4G, white aerial for Wi-Fi) supplied on the respective camera connector.
2.
Insert the nano-SIM (not included) into the appropriate slot of the camera with the device switched off (see next
image).
IMPORTANT: It is recommended to disable the SIM card PIN from your mobile phone or tablet before inserting
the SIM card into the camera. If necessary, refer to section 5 of this guide to disable the PIN of the SIM already
inserted in the camera.
IMPORTANT: Some mobile network operators can introduce major delays or blockages in camera connections.
3.
When recording to a micro SD card (not included), insert the SD memory card into the SD memory card slot of
the camera when the power is off (see next picture). Format the SD card from camera settings on the web page
or from the app.
4.
Place the camera in a location with good 4G signal reception and then power the camera (power supply not
supplied). Within a few minutes of switching on, the camera automatically connects in 4G to the internet
network.
DS1099-077
.
5
Advertisement
Table of Contents
