Keysight Technologies N9020B Installation Note page 9

Refer to the following conditions:
— If the analyzer is already equipped with N9020B-B40, N9020B-DP2 and N9020B-MPB, DO
NOT PROCEED with the installation of this upgrade kit. If all three of these options are
already installed, this kit is not needed. Other, less expensive upgrade kits should be used.
— If the analyzer has N9020B-BBA, DO NOT PROCEED with the installation of this kit. N9020B
analyzers with Option BBA do not have sufficient room to install the two additional boards
required for analysis bandwidths of 85 MHz and wider.
— If the analyzer's frequency range option is 503, 508, 513, or 526, DO NOT PROCEED with the
installation of this kit. This kit is only for analyzers with frequency range options 532, 544,
or 550. Other kits are available to upgrade analyzers with the lower frequency range
options.
5. On the analyzer, press System, Show Hardware. Note the Part #, Matl Rev, Rev, OF Rev, and
Hw Id of the Front End Controller and Digital IF in the table below.
Assembly Name
Front End Controller
Digital IF
6. Refer to step 4 and
— If the analyzer has N9020B-CR3 and/or N9020B-CRP installed verify that it also has a Front
End Controller with Hw Id of 75. If the Front End Controller has a Hw Id of 75, you do not
need to perform the Replace Front End Controller procedure.
— If the analyzer has N9020B-DP2, and/or N9020B-MPB installed, verify that it also has a
Front End Controller with Hw Id of 75 or 170 and a Digital IF with Hw Id of 34.
— If either of the listed options is present and the Front End Controller has Hw Id of 75 or
170 and the Digital IF has Hw Id of 34, It is only necessary to install the Wideband
Analog IF and Wideband Digital IF boards and associated cables, redeem the required
license entitlements, and perform the necessary adjustments and performance
verification tests.
— If either of the listed options is present and the Digital IF has Hw Id of 34, but the Front
End Controller does not have a Hw Id of 75 or 170, it will be necessary to perform the
Replace Front End Controller procedure, install the Wideband Analog IF and Wideband
Digital IF and associated cables, redeem the required license entitlements, and perform
the necessary adjustments and performance verification tests.
Installation Note N9020-90289
Part # Matl Rev
step 5:
Rev OF Rev
Installation Procedure
Hw Id
9