Set Ipx Network <Network_Name - 3Com OfficeConnect 3CP4144 Cli User's Manual

set ipx network
<network_name>
rip_flags [METRICS, SEND_REQUEST]
router_id [router_id]
Sets parameters for IP routing to the specified IP router address, which is the
gateway to an Autonomous System.
Parameters
autonomous_system_number Autonomous system number.
table_maximum_size
metric_maximum_entries
rip_flags
Router_id
delay_ticks [number]
diagnostics [DISABLE | ENABLE]
maximum_learning_retries [number]
netbios [ENABLE | DISABLE]
netbios_name_cache [DISABLE | ENABLE]
netbios_cache_timer [seconds]
netbios_max_hops [number]
packet_maximum_size [number]
rip [BOTH | DISABLE | LISTEN | RESPOND_ONLY | SEND]
rip_age_multiplier [number]
rip_packet_size [number]
rip_update_interval [number]
sap [BOTH | DISABLE | LISTEN | RESPOND_ONLY | SEND]
sap_age_multiplier [number]
sap_packet_size [number]
sap_nearest_replies [ON | OFF]
sap_update_interval [number]
Sets parameters for the specified IPX network.
Parameters Description
<network_name> Designation of the IPX network. Maximum size is 32 characters.
delay_ticks Interval in number of ticks it takes to reach this IPX network.
diagnostics Whether or not to send diagnostic packets to this IPX network.
maximum_learning_ Number of times this network will resend packets to learn its directly
connected neighbors.
retries
Description
Maximum number of IP routes system can hold in its table.
Default: 1000
Most next hop entries the system table can maintain.
Flags indicate at which level a RIP instance is disabled or
configured. Choices are:
METRICS - Specifies how to increment metrics using
RFC1058.
SEND_REQUEST - Sends a RIP request for routing information
when an interface first comes up.
The IP station address of the ip router.
CLI Commands B-29