Ipx Routing - 3Com OfficeConnect 3CP4144 Cli User's Manual

Access Lists

IPX Routing

add dns server <domain name> primary_address <ip address>
secondary_address <ip address>
To create an entry that will learn addresses using PPP, use the command:
add dns server <domain name> vc <vc name>
To display the contents of the DNS Server table, use the command:
list dns servers
To delete a domain entry, use the command:
delete dns server <domain name>
Access Lists enable you to restrict which Remote Subnets are allowed to access the
Management services of the OCR812.
To add a remote subnet to the access list, use the following command:
add access <ip subnet address>
To remove a subnet from the access list:
del access <ip subnet address>
To display the access list:
list access
In addition to adding subnets to the list, you can enable access to all hosts on the
local LAN.
To enable LAN access:
enable lan access
To enable the Access List functionality:
enable access
To show the status of the Access List functionality:
show access
The OfficeConnect Remote 812 can be configured as an IPX router to forward IPX
packets between the local LAN interface and one or more remote sites. A
forwarding table is maintained which specifies which interface to route an IPX
packet based on the destination IPX network number. Entries into the forwarding
table are both static and dynamic. Static entries are based on the LAN's network
number, the remote site WAN interface number, and user configured static routes.
Dynamic entries are added when RIP is enabled and routes are learned from
neighboring routers.
IPX Routing 6-15