Error 60: Spindle Mlamping Mystem Monitoring Error; Error 61: End Damping Error - Keba ServoOne Device Help

11 Alarms & warnings
ID No.: 0842.26B.5-01 Date: 09.2020
11.6.52.2 Error 58-2 (emergency code 6100h)
Cause: Hydraulics, tracking error monitoring: maximum tracking error exceeded
Suggested steps:
Please check the parameterization.
Hydraulics, cyclic Error during the cyclic execution of the
l
processing hydraulics.
In any case look at init outputs in the message
l
window of the DriveManager.
11.6.53 Error 60: Spindle mlamping mystem monitoring
error
11.6.53.1 Error 60-1 (emergency code 6100h)
Cause: Tool not clamped correctly while in operation
Suggested steps:
Do not switch on drive while tool is not clamped correctly
11.6.53.2 Error 60-2 (emergency code 6100h)
Cause: Unknown combination of input signals
Suggested steps:
Check input wiring and settings
11.6.53.3 Error 60-3 (emergency code 6100h)
Cause: Clamping pressure was not applied properly
Suggested steps:
Check clamping pressure generation
11.6.54 Error 61: End damping error
11.6.54.1 Error 61-1 (emergency code 6100h)
Cause: End damping speed limitation error
Suggested steps:
Switch off/on device. Please contact your service provider if this error occurs again
ServoOne - Device Help 453