Bartec Syscom MR3000 Series User Manual page 65

65
Contacts
In this subsection, it is possible to add Contacts for the notification service. Contacts are people
who receive notification from the MR3000. To add a new contact click on the Add button. To edit a
contact, just click the corresponding line. Clicking the Del button will delete the corresponding
contact.
Once clicked on a contact line or on the add button, a window like in Fig. 5.4.8 is shown. In the first
part (Contact details), it is possible to insert name and e-mail of the contact. In the second part
(Messages), the user can choose the desired messages to be sent to the contact.
The condition to trigger a message can either be related to Event recording or – regardless of the
recording of an event – when the vibration reaches the Alarm threshold (see Section 5.4.3). The
difference between the two methods is:

Alarm messages related to Event recording include additional information, like the event
peak, peak of the vector sum of the event and the dominant frequency of the event. To use
this option, you have to make sure that the trigger threshold is below the alarm threshold.
Such messages are sent immediately after the event is recorded, i.e. the vibration is again
below the threshold level or the max recording time has elapsed (see Section 5.4.3).
Messages sent to an E-Mail address may additionally include a graphical presentation of the
waveform data (PNG graphics). The waveform data and the FFT are NOT calculated if the
duration of the event exceeds 60 seconds (@ 1000 sps sampling rate).

Alarm messages based on the Alarm threshold are independent from event recording. They
are sent immediately after the alarm threshold is exceeded. In that case, the alarm threshold
can be also set below the alarm threshold.
Additionally you may send other information to any of the contacts, as for example a Daily
Message (see Section 5.4.5), as you can see in the following section "Messages".
If the Network option is active, there are additional messages for common Alarm and common
trigger (see Section 5.6).
After having changed something on the contact list, don't forget to click on the Apply button.
In Fig. 5.4.9 the main page related to contacts is displayed. In each line, the selected messages for
the related contact are highlighted.
Messages
In this section the user can configure each type of notification by inserting the desired information.
In details, it is possible to set the following messages:
Figure 5.4.9. Summary of contact definition.