Assa Abloy Corbin Russwin SE LP10 ML20600 Installation Instructions Manual page 12

Mortise lock

3. Handing of Lock Body

Step 1) Move the red locking screw to side of

lock body being locked (Fig. 3a)

Step 2) Push in latch then depress catch plate

with screw driver (Fig. 3a)

Step 3) Pull latch out of lock body

and turn latch over (Fig. 3b)

Step 4) Push in latch while holding

screw driver behind latch tail (Fig. 3c)

Note: Push in latch until catch plate is no longer

depressed (Fig. 3d)

Step 5) Rotate lock front to match

bevel of door as shown (Fig. 3e)

7) Installation Instructions (Continued)

Fig. 3b

Fig. 3e

SE LP10 ML20600 Mortise Lock

RED Locking Screw

MAKE SURE CATCH PLATE IS

EVEN W/TOP SURFACE

Fig. 3c

rights reserved. Reproduction in whole or in part without the express written

permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.

Catch Plate

Fig. 3a

GOOD

BAD

Fig. 3d

WARNING:

LOCK-IN CAN

OCCUR IF LATCH

IS NOT PROPERLY

INSTALLED

Table of Contents