Assa Abloy LOCKWOOD Sliding Door Latch Installation Instructions

Sliding Door Latch
Installation Instructions
Application: Self latches sliding door on closure.

Pack Contents:

2 x Chassis
Assemblies
Strike Cover

Door Specifications:

Snib tabs away
from door frame

2. Fitting Chassis Assemblies to Frame

Align chassis assemblies to either side of doorframe. Screw the chassis to the door frame
(do not tighten at this stage) using the 2 x M4 fixing screws provided. Ensure the snib lever is
facing away from the door jamb.
Drive Bar
Strike
Snib tabs away
from door frame
Tools Required: • Drill
• 3.0mm Drill Bit
Inside Cover
Screw Pack
Centre line of fixing
screw holes

1. Fixing Holes Required in Frame

Refer to door specification drawing to determine hole
centres. Drill three holes into the door frame ø10mm, the top
and bottom holes spaced 20mm from centre hole and inline
vertically. Remove any burs from the edge of the holes.
Note: The centre fixing hole should be at least 1.5m from the
floor to comply with swimming pool fencing regulations.

3. Assemble Latch

Insert the latch to the inside chassis assembly.
• 10.0mm Drill Bit
• Phillips Screwdriver
Outside Cover
Latch
ø10mm
ø10mm
ø10mm
Ensure beak
points down