Toshiba SD-H400-S-TU Installation Manual page 65

5Troubleshooting-New.fm Page 52 Monday, June 9, 2003 3:04 PM
C h a p t e r 5
I accidentally changed channels with my
cable or satellite box's remote control.
I accidentally changed channels with my
TV or VCR's remote control.
I can't get the channel to change.
52
control card that came with the TiVo Viewer's Guide for instructions on installing
batteries.
• You may not have the correct input selected on your TV. Use the "Input," "Source,"
"Select," or "TV/Video" button on your TV's remote to change the input. If you are
passing the signal through your VCR (as in Setup 4 in this guide), you may need to
select the correct input on the VCR as well.
• After you have connected the SD-H400, you should use the SD-H400's remote
control to change channels. If you use your cable or satellite box's remote to change
the channel, the TiVo service won't register that the channel has changed. If you
accidentally change channels with another remote, press CHAN UP or CHAN DOWN
on the SD-H400's remote once. The SD-H400 will then be able to register the channel.
• If you use your TV's or VCR's remote to change the channel, the TV will no longer
display the video signal from the SD-H400. To return to viewing video from the SD-
H400, return to the channel that your TV or VCR was tuned to. You may also need to
press the Input, Source, or TV/Video button on your TV's remote to change the input
(i.e., the video signal your TV is displaying).
If you have cable without a cable box:
• Be sure that you are using the SD-H400's remote and that you hold it so that the TiVo
button points toward the SD-H400.
• Press any button on the remote. Make sure that the batteries are positioned correctly in
the remote. If they are correctly positioned, try a new set of batteries.
T r o u b l e s h o o t i n g