Bcd And D/A Output Specifications - KYOWA WGA-910A Series Instruction Manual

4-3. BCD AND D/A OUTPUT SPECIFICATIONS

4-3-1. BCD / Binary output
Output .............................
Input ...............................
Setting contents ..............
4-3-2. D/A output
Output Voltage..................
Output Current..................
Insulation Voltage.............
Conversion Speed.............
Nonlinearity......................
Setting contents ................
BCD data: 20 bits (4-bit ×5-digit)
Binary data: 18 bits (offset binary)
Minus code: 1 bit
Over: 1 bit
EOC (End Of Conversion): 1 bit
Format: Open-collector
Max load capacity: 30 VDC, 20 mA (load resistance)
Number of points: 2
Contents: Data hold input. ......... Negative logic (Hold at "L")
Output prohibit input.....Negative logic (Prohibition at "L")
Type: Open collector or Non-voltage contact signal
Voltage 12 VDC and current 5 mA can be applied.
Transmission speed: Approx. 16, 32, 64, 125, 250, 500 and 1000 times / sec.
Porality logic, EOC logic, Data logic: Negative or positive logic
Data form: BCD, Binary
BCD classification: Peak value, bottom value
±10 V (load resistance 2 kohm or more), arbitrary scaling is available.
4 to 20 mA (load resistance 500 ohm or less)
4 to 20 mA output is fixed when the voltage 0 to 10 V is applied.
250 VAC for 1 minute (output voltage and output current are non-insulated)
2000 times/sec
±0.1 %FS
D/A display: Zero disp. (Displayed value when the voltage 0 V is outputted)
Full disp. (Displayed value when the voltage 10 V is outputted)
D/A classification: Peak value, bottom value
Changeable
27