Specifications; Recommended Cable Lengths - Campbell 05103 Product Manual

NOTE
CAUTION
6.

Specifications

The wind monitors are manufactured by R.M. Young and cabled by Campbell
Scientific for use with our data loggers. Cable lengths for the wind monitors
are specified when the sensors are ordered. TABLE
recommended cable length for mounting the sensor at the top of the
tripod/tower by using a CM200-series crossarm.
TABLE 5-1. Recommended Cable Lengths
CM106B CM110
4.2 m 4.2 m
(14 ft) (14 ft)
Maximum cable length is 304.8 m (1000 ft).
Do not use cable lengths greater than 30 m (9 ft) in
electrically noisy environments.
TABLE 6-1, TABLE 6-2, and TABLE
direction, and physical specifications, respectively.
Features:
Rugged enough for harsh environments
•
Constructed with thermoplastic material that resists corrosion from
•
sea-air environments and atmospheric pollutants
Ideal for wind profile studies
•
Compatible with the LLAC4 4-channel Low Level AC Conversion
•
Module, which increases the number of anemometers one data logger
can measure
Compatible with Campbell Scientific CRBasic data loggers:
•
CR200(X) series, CR300 series, CR6 series, CR800 series,
CR1000X, CR1000, CR3000, CR5000, and CR9000(X)
5-1
CM115 CM120 UT10
5.8 m 7.3 m 4.2 m
(19 ft) (24 ft) (14 ft)
6-3 provide the wind speed, wind
Wind Monitor Series
gives the
UT20 UT30
7.3 m 11.3 m
(24 ft) (37 ft)
5