3.
Initial Inspection
3.1
Ships With
4.
QuickStart
Upon receipt of the wind monitor, inspect the packaging and contents for
•
damage. File damage claims with the shipping company. Immediately
check package contents against the shipping documentation (see Section
3.1, Ships With
). Contact Campbell Scientific about any discrepancies.
(p. 2)
•
The model number and cable length are printed on a label at the
connection end of the cable. Check this information against the shipping
documents to ensure the expected product and cable length are received.
The wind monitors ship with:
(1) Allen wrench from manufacturer
(1) Bearing spacer from manufacturer
(1) Calibration sheet
(1) Unthreaded aluminum pipe, 1-inch IPS, 12-inch length
A video that describes data logger programming using Short Cut is available at:
www.campbellsci.com/videos/cr1000x-datalogger-getting-started-program-
part-3. Short Cut is an easy way to program your data logger to measure this
sensor and assign data logger wiring terminals. Short Cut is available as a
download on www.campbellsci.com. It is included in installations of
LoggerNet, PC200W, PC400, or RTDAQ.
The following procedure also describes programming with Short Cut.
1.
Open Short Cut and create a new program.
2.
Double-click the data logger model.
Wind Monitor Series
2