Table of Contents
Advertisement
Rack PDM Charger
Installation and Operation Manual
From left: Ethernet (LAN), Ethernet (PC) and USB.
When connecting several (up to four) Rack PDM Chargers over Ethernet, it is possible
to connect them in series using the two Ethernet connections. Power over Ethernet is
not supported.
Figure 12. Connecting Rack PDM Chargers in series using Ethernet cables
1
Open the top cover, see
2
If a single Rack PDM Charger is used, connect the Ethernet cable or USB cable
to the connections shown in
shall be connected in series, connect the Ethernet cables to the connections
shown in
3
Let the Ethernet/USB cables run on top of the cable support holders, see
figure 9
4
Close the top cover.
The USB Interface supports USB 2.0 Full speed. One Mini-B Receptacle USB
connector is used. The USB connection is used for communication with a PC. Power
over USB is not supported.
The USB connection is used for connecting the Rack PDM Charger directly to a PC or
to a LAN for the purpose of upgrading or configuring the Rack PDM Charger itself or
handsets placed in the charger.
2.1.6 SOFTWARE INSTALLATION
NOTE: This section is applicable for the Rack PDM Charger only.
21/1531-ANF 901 43 F 2017-04-25
LAN
PC
Charging Rack 1
figure 7
figure 12
on page 15.
on page 13.
LAN
Charging Rack 2
on page 11.
figure 11
on page 14. If several Rack PDM Chargers
PC
15
Advertisement
Table of Contents
