Mitel Rack PDM Charger Installation And Operation Manual page 3

Rack PDM Charger
Installation and Operation Manual
1. INTRODUCTION
This document describes how to install, configure and operate the Rack PDM Charger.
This Rack Charger is aimed DT390, DT69x, DT4x3, Mitel 5613 and 5614 for MiVoice
MX-ONE and Mitel 5603, 5604, 5607, 5624 for MiVoicce Business and MiVoice 250.
Model
Rack PDM Charger
Note: For the Mitel 5624 (WiFi) wireless
handset, this Rack PDM Charger only
provides charging.
NOTE: The Rack PDM Charger is designed to be connected to an Ethernet based local
area network.
Each Rack PDM Charger can charge up to six handsets simultaneously.
The USB port on the Rack PDM Charger is used to connect the Rack PDM Charger to
a CPDM3/WSM3, or to a PC running the Portable Device Manager (WinPDM/PDM).
The CPDM3/WSM3 or WinPDM can be used to configure or upgrade either the Rack
PDM Charger itself or any handsets placed in the Rack PDM Charger.
The Ethernet ports can be used to connect up to four Rack PDM Charger to a single
LAN outlet.
See 2.1.5 Communication Cable Connection
connect Rack PDM Chargers using the Ethernet and USB ports.
Figure 1. Rack PDM Charger.
This document is intended as a guide for installation, maintenance and
troubleshooting.
Supply voltage 100-240VAC/0.7A 50/60 Hz
21/1531-ANF 901 43 F 2017-04-25
Power Supply for Rack PDM
Charger
Features
- Charging slots for handsets.
- Ethernet and USB connection used for
upgrade and configuration of handsets
and Rack PDM Chargers (through a LAN
or PC connection).
-
on page 14 for more information on how to
Building fuse for fixed
installation
10 A maximum
3