Table of Contents
Advertisement
Installation and Operation Manual
Desk PDM Charger
The USB Interface supports USB 2.0 Full speed. One Mini-B Receptacle USB
connector is used. The USB connection is used for communication with a PC. Power
over USB is not supported.
Figure 3. Connection to WinPDM (Windows Version)
2.1.1 SOFTWARE INSTALLATION
The charger is delivered with pre-installed software and it is possible to upgrade the
charger software. See Installation and Operation Manual for WinPDM, or Installation
and Operation Manual for CPDM3 for instructions on how to upgrade the charger.
2.2 DESK PDM CHARGER CONFIGURATION
Each Desk PDM Charger need access to DHCP to receive an IP address
automatically. If no DHCP is accessible it is possible to configure the IP address with
WinPDM (Windows Version).
If the Desk PDM Charger is configured to run DHCP, connect the network cable and
the charger will automatically receive an IP address. If the charger is not configured to
run DHCP the charger will use the setup IP addresses.
The following parameters exist for Desk PDM Charger and can be changed via
WinPDM/CPDM3:
Parameter
Ethernet Bit rate
Ethernet connector
Ethernet duplex
DHCP Enabled
Charger IP address
Subnet mask
Default gateway IP address
DNS IP address
Charger IP port
Service Discovery Enabled
Service Discovery Domain
DH IP address (one DH only)
DH IP port
1.Currently only "auto" setting is available.
Follow this instruction to set Desk PDM Charger parameters:
7
Figure 3.
Description
1
auto (default)
1
auto (default)
1
auto (default)
Yes (default), No
192.168.0.101 (default)
255.255.255.0 (default)
192.168.0.1 (default)
192.168.0.2 (default)
12346 (default)
Yes (default), No
Name of domain
192.168.0.3 (default)
10147 (default)
20/1531-ANF 901 43 D 2017-03-22
Advertisement
Table of Contents
