Mitel Rack PDM Charger Installation And Operation Manual page 8

Rack PDM Charger
Installation and Operation Manual
Examples of Ways to Mount the Rack PDM Chargers
Different ways to mount the Rack PDM Charger is shown in
possible to set up different combinations of Rack PDM Chargers and Battery Pack
Chargers. A maximum of four Rack PDM Chargers (or Battery Pack Chargers) can be
serially connected to the same LAN source.
Installation Steps for the Rack PDM Charger
The installation is done in three steps:
1 Placing on table or wall mounting.
2 Electrical installation.
3 Communication cable connection.
Installation Steps for the Rack PDM Charger
The installation is done in two steps:
1 Placing on table or wall mounting.
2 Electrical installation.
2.1.2 PLACING ON A TABLE
If the Rack PDM Charger shall be placed on table, use the table adapters included in
the delivery as follows:
1 Mount the two table adapters in the two outer holes in the bottom cover of the
Rack PDM Charger as shown in
2 Mount the four rubber feet as shown in
Figure 2. Mounting of table adapters and rubber feet.
21/1531-ANF 901 43 F 2017-04-25
figure 6
figure 2 on page 8.
figure 2 on page 8.
on page 11. It is
8