Table of Contents
Advertisement
Rack PDM Charger
Installation and Operation Manual
Figure 8. The rectangular cover that shall be removed and changed to a cable
support holder with a mains power supply cord run through it.
5
Remove the C14 connector from the additional charger. Cut and strip the mains
power supply cord coming from the additional charger to the length required.
6
Run the power supply cord from the additional charger through the cable support
holder of the previous charger, see
Figure 9. Securing the mains power supply cable.
7
Connect the power supply cord from the additional charger to the unused
terminal block in the charger closer to the AC power source. Note the embossed
markings L, earth symbol and N, see
21/1531-ANF 901 43 F 2017-04-25
figure 9
on page 13.
figure
10.
13
Advertisement
Table of Contents
