Mitel Rack PDM Charger Installation And Operation Manual page 16

Rack PDM Charger
Installation and Operation Manual
The charger is delivered with pre-installed software and it is possible to upgrade the
charger software. Refer to the Installation and Operation Manual for the Device
Manager or the PDM for instructions on how to upgrade the charger.
2.2 RACK PDM CHARGER CONFIGURATION
NOTE: This section is applicable for the Rack PDM Charger only.
Each Rack PDM Charger need access to DHCP to receive an IP address
automatically. If no DHCP is accessible it is possible to configure with WinPDM
Windows Version.
If the Rack PDM Charger is configured to run DHCP, connect the network cable and
the Rack PDM Charger will automatically receive an IP address. If the Rack PDM
Charger is not configured to run DHCP the Rack PDM Charger will use the setup IP
addresses.
21/1531-ANF 901 43 F 2017-04-25 16