Table of Contents
Advertisement
Rack PDM Charger
Installation and Operation Manual
3. COMMISSIONING
The commissioning includes the following:
•
Installation test
•
Charging
•
Communication with WinPDM or CPDM3/WSM3
Installation Test
For Installation test, see chapter
Charging
To verify that the charging works, do as follows:
1
Check that the LED on the front of the charger(s) is lit.
2
Place a handset in a charging slot. Start of charging may be indicated differently
depending on handset model.
Communication with WinPDM and CPDM3/WSM3
NOTE: The communication test is applicable for the Advanced Charger Rack only.
See
figure 11
Follow these instructions to start the WinPDM/CPDM3/WSM3:
If you are using a CPDM3/WSM3:
1
Check that the Rack PDM Charger is connected.
2
Open a web browser and enter the URL to access CPDM3/WSM3.
3
Click on "Device Manager". The Device Manager window appears.
4
Go to the "Devices" tab and verify that the Charger Rack is online (it may take up
to 15 sec).
If you are using the WinPDM (Windows Version):
1
Check that the Rack PDM Charger is connected to your PC.
2
Start WinPDM (Windows Version).
3
Go to the "Devices" tab and verify that the Charger Rack is online.
For instructions on how to verify that the charger parameter setting works, and for
further instructions, see Installation and Operation Manual for WinPDM, Windows
version, or the CPDM3/WSM3 Installation Manual for instructions on how to upgrade
the charger.
21/1531-ANF 901 43 F 2017-04-25
Installation Test
on page 14 to see the communication connections to the charger.
on page 10 or page 14.
18
Advertisement
Table of Contents
