Assa Abloy Corbin Russwin Access 600 ML20600 TCRNE1 Series Installation Instructions Manual page 12

ML20600 Series Mortise Lock
9. Installing Controller
Please follow these steps prior to installing inside escutcheon to prevent
any damage caused by pinching wires:
a. Feed controller harness earth ground into and around behind rim
of large upper hole of the mounting plate (Fig. 9a, b).
Controller PCB
10. Connect ElectroLynx
a. Connect P5 (7 Pin Connector) from reader board to J5 on interior
escutcheon PCB assembly (Fig. 9b).
b. Connect ElectroLynx harness (4 and 8-pin) from door harness to
ElectroLynx harness on interior PCB assembly (Fig. 9a-c).
NOTES: Neatly fold the wires into the remaining space to prevent
PCB Layout - Wire Assignments - ElectroLynx Assembly (Molex)
J2
1-Violet Lock Neg
(Solenoid, neg)
2-Gray Lock Pos
(Solenoid, pos)
Copyright © 2017 Corbin Russwin, Inc., an ASSA ABLOY Group company.
All rights reserved. Reproduction in whole or in part without the
express written permission of Corbin Russwin, Inc. is prohibited.
7) Installation Instructions (Continued)
Inside of
Door
Earth
J5
ground
Fig. 9a
®
pinching wires when mounting escutcheon.
Do not tuck extra mortise lock body wires back
inside the lock body cylinder hole.
Connectors go on only one way.
Do not offset connector and be sure they are
completely seated.
J1
3-Pink 1- Black
DPS (NC) PWR NEG
4-Tan 2-Red
DPS (COM) PWR POS
J1
3-White 5-Orange 7-Brown
DATA 1 RX (NO) EGND
4-Green 6-Blue 8-Yellow
DATA 0 RX (COM) LED
12
J2
P5
Fig. 9b
8-pin
ElectroLynx
Fig. 9c
4-pin
ElectroLynx