Yetter Nutrient Pro 4000 Series Operator Installation & Instruction Manual page 11

ASSEMBLY INSTRUCTIONS (ToolBar Application)
Step 2: Assemble the coulter to the shank using the 2) ¾ X 2" bolts.
Step 3: Attach the fertilizer hose to the tube on the fertilizer knife. When routing the hose use your best judgement to prevent
excessive wear, pinching, or pulling. After fertilizer hose installation, lower the toolbar & manually lift the fertilizer coulter to full
upward travel to inspect clearance. On liquid application, if necessary, cut down the fertilizer tube as close to the top of the knife as
possible. This helps minimize leverage of the fertilizer hose pulling on the knife tube.
Step 4: (if applicable) Assemble the 4000-070 & 4000-071 sealer wheel assembly. Attach the sealer arm assembly to the coulter
assembly using 3) ½ X 2" bolts. Assemble the sealer bracket & spacer using 2) ½ flat washers, 2) ½ lock washers, & 2) ½ hex
nuts. Assemble the closing wheel assembly to the sealer bracket. Use the round hole if using cast closing wheel, use the D-bolt
hole if using the Sharktooth closing wheel. Use your judgement to adjust the closing wheel angle & the spacing off of the row.
11