EZ-ACCESS PATHWAY HD Code Compliant Modular Access System Installation Supplement Manual page 8

IN
Attach 1-1/2" square closure post to the top rail and midrail using a 5/16"-18 x 2-1/4" hex bolt and
2.4.
5/16" flat washer. Do not tighten fully at this time (FIG. 2.2).
2.5. Attach the upper closure bracket to the 1-1/2" square closure post using a 5/16"-18 x 2-1/4" hex
bolt, 5/16"-18 locknut, and 5/16" flat washer through the second hole from the top. Do not tighten
fully at this time. Orient the bracket as shown with respect to the closure post and the upper step
guard post (FIG. 2.2).
Attach lower closure bracket to the 1-1/2" square closure post and barrier using 5/16"-18 x 2-
2.6.
1/4" hex bolt and 5/16" flat washer through the post and bracket into the threaded inserts in the
barrier. Orient the bracket as shown with respect to the closure post and the upper step guard
post (FIG. 2.2).
Attach the two closure brackets to the upper step guard post using 5/16"-18 x 2-1/4" hex bolts,
2.7.
5/16"-18 locknuts, and 5/16" flat washers (FIG. 2.3).
2.8. Install a 1-1/2" square tube plug in the top of the 1-1/2" square closure post. Use a rubber mallet
or similar tool to fully seat as needed (FIG. 2.4).
Tighten all fasteners securely.
2.9.
Installation Supplement for PATHWAY® HD Steps
FIG. 2.2
FIG. 2.4
FIG. 2.3
Page 8 of 29