EZ-ACCESS PATHWAY HD Code Compliant Modular Access System Installation Supplement Manual page 6

IN
1.3. Set the upper lip of the riser onto the platform in the desired location (FIG. 1.2).
1.4. Install two step guards into the corner pockets of the step until the lower post rests on the ground or
aligns with the bottom of the lower corner pockets (FIG. 1.2).
1.5. Tighten two 3/8"-16 x 1/2" long headless cup point socket setscrews in each corner pocket securely
(FIG. 1.2).
1.6. Install 1-1/2" square x 3/16" wall tube plugs in the tops of the 1-1/2" step guard posts. Use a rubber
mallet or similar tool to fully seat as needed (FIG. 1.2).
1.7. If installing a step on the 5-ft. (nominal) side of a PATHWAY HD platform, skip to 'STEP HANDRAILS'
section.
Installation Supplement for PATHWAY® HD Steps
Do not lean, walk, or otherwise bear weight on the step until installation is complete.
FIG. 1.2
Page 6 of 29