1. Manuals
  2. Brands
  3. EZ-ACCESS Manuals
  4. Ladders
  5. Fortress OSHA Series
  6. Installation manual

EZ-ACCESS Fortress OSHA Series Installation Manual

Adjustable temporary stair system
Hide thumbs
1
2
3
4
5
6

Advertisement

Table of Contents

Fortress OSHA Stair System
Adjustable Temporary Stair
Rated Load: 100 psf, 300 lbs. concentrated
3-Tread at 34"
3-Tread at 25.5"
4-Tread at 34"
4-Tread at 42.5"
®
© EZ-ACCESS
, a division of Homecare Products, Inc. All rights reserved.
All text and images contained in this document are proprietary and may not be shared, modified,
distributed, reproduced, or reused without the express written permission of EZ-ACCESS.
Manufactured in the USA
12963 REV 10-14-14

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Fortress OSHA Series and is the answer not in the manual?

Questions and answers

Related Manuals for EZ-ACCESS Fortress OSHA Series

Summary of Contents for EZ-ACCESS Fortress OSHA Series

  • Page 1 , a division of Homecare Products, Inc. All rights reserved. All text and images contained in this document are proprietary and may not be shared, modified, distributed, reproduced, or reused without the express written permission of EZ-ACCESS. Manufactured in the USA...
  • Page 2 1. TOOLS TYPICALLY NEEDED:  Tape measure  Level  Ratchet wrench  1/2” socket (deep well)  9/16” socket (deep well) 2. INSPECT (BEFORE USE):  Ensure all fasteners and locking mechanisms are in place and tightened before use. Regularly check and tighten as needed.
  • Page 3 FIG. 1 Part No. Fortress OSHA Stair Descriptions Diagram Letter 13193 3 Tread Platform (Includes Legs) 13105 4 Tread Platform (Includes Legs) (Not Shown) 13202 3 Tread Platform with Drain Holes (Includes Legs) (Not Shown) 13183 4 Tread Platform with Drain Holes (Includes Legs) (Not Shown) 13207 3 Tread Platform with Oversized Feet (Includes Legs)
  • Page 4 4. INSTALLATION: 4.1. Rated Load: 100 psf, 300 lbs. concentrated. 4.2. OSHA Riser Safety Pins (FIG. 1D) must ALWAYS be installed in the riser hangers on the platform corner pockets before use (FIG. 2). If any hardware is missing, DO NOT USE system and contact manufacturer. 4.3.
  • Page 5 FIG. 2 FIG. 3 FIG. 4 Page 5 of 6...
  • Page 6 5. OVERSIZED FEET INSTALLATION (OPTIONAL EQUIPMENT): 5.1. Loosen the leg adjustment bolts in each platform and riser corner pocket, but do not remove; then remove the existing legs (FIG. 3). 5.2. Insert the legs included with the oversized feet into the corner pockets with the open side of the channel oriented toward the leg adjustment bolt &...

Table of Contents