EZ-ACCESS PATHWAY HD Code Compliant Modular Access System Installation Supplement Manual page 18

IN
Drill a 1/8" pilot hole on the underside of the short leg of the 90° bend at 3/4" from the end,
6.7.
through one wall of both the 90° bend and the swaged end of the top transition bend (FIG. 6.2).
6.8. Attach saddle of the handrail bracket to 90° bend and attach the 90° bend to the top transition
bend using 1/4" x 1" long self-drilling, self-tapping pan head Phillips screws (FIG. 6.2).
6.9. Trim the long leg of the 90° bend until it aligns (approximately) with the edge of the platform.
6.10. Use a file to deburr all sharp edges from trimming.
6.11. Install a 1-1/2" square plug in the top of the handrail bracket standoff and a 1-1/2" diameter plug
in the end of the 90° bend. Use a rubber mallet or similar tool to fully seat as needed (FIG. 6.3).
6.12. Tighten all fasteners securely.
FIG. 6.2
FIG. 6.3
Installation Supplement for PATHWAY® HD Steps Page 18 of 29