Section 11: Optional Equipment - Steps On Platform Extender; Section 12: Leveling Feet - EZ-ACCESS PATHWAY HD Code Compliant Modular Access System Installation Supplement Manual

OPTIONAL EQUIPMENT – STEPS ON PLATFORM EXTENDER
IN
11.
1.1. Assemble and set all platforms and platform guards or two-line rails (including the platform extender
and platform extender closure) as described in the main PATHWAY HD Code Compliant Modular
Access System Installation Manual.
1.2. Assemble the step as described in this manual with upper loops on both sides of the step and the step
centered on the 1-ft x 5-ft platform extender (FIG. 11.1).
FIG. 11.1
LEVELING FEET
12.
12.1. Leveling feet are provided with the system step. When adjusting the system step, be mindful of
applicable building codes and ADA guidelines. The ground must be leveled at the proper height
with respect to the platform.
12.2. Insert a leveling foot into the bottom of the lower step guard post, oriented so the foot is under the
riser and sitting on the ground (FIG. 12.1). This may require lifting the step.
12.3. Drill a 13/32" hole through the leg of the leveling foot, directly under the step lower corner pocket
and parallel to the step. Insert 3/8"-16 x 2-1/2" long hex bolt, 3/8"-16 locknut, and 3/8" flat
washer, oriented as shown, through the drilled hole (FIG. 12.1). Tighten securely.
12.4. Repeat on the opposite side of the step, if needed.
FIG. 12.1
Installation Supplement for PATHWAY® HD Steps
EZ-ACCESS will not be responsible for any costs or liabilities resulting from use of the
leveling feet.
Page 28 of 29