Section 2: Two-Line Rail Closure - EZ-ACCESS PATHWAY HD Code Compliant Modular Access System Installation Supplement Manual

Steps

Hide thumbs Also See for PATHWAY HD Code Compliant Modular Access System:

Table of Contents

TWO-LINE RAIL CLOSURE

2.1.

Install a platform angle post in the open corner pocket where the two-line rail will be attached

(FIG. 2.1). Secure in place as described in the 'HANDRAILS' section of the PATHWAY HD Code

Compliant Modular Access System Installation Manual.

2.2.

Insert 1-1/2" diameter 5/16"-18 threaded inserts in both ends of the 1-1/2" diameter top rail and

1-1/2" square 5/16"-18 threaded inserts in both ends of the midrail and barrier. Use a rubber

mallet or similar tool to fully seat as needed (FIG. 2.1).

The top rail, midrail, and barrier are specific to the platform size and should not require trimming.

2.3.

Connect the top rail, midrail, and barrier to the platform angle post using 5/16"-18 x 1" hex bolts

and 5/16" flat washers in the locations shown (FIG. 2.1).

Do not use a washer with the lowermost bolt.

Installation Supplement for PATHWAY® HD Steps

FIG. 2.1

Page 7 of 29

Table of Contents

Need help?

Do you have a question about the PATHWAY HD Code Compliant Modular Access System and is the answer not in the manual?