Section 1: Getting Started - EZ-ACCESS PATHWAY HD Code Compliant Modular Access System Installation Supplement Manual

IN GETTING STARTED
1.
1.1. Before beginning the assembly process, install the PATHWAY® HD Code Compliant Modular Access
System, except DO NOT install a platform guard or two-line rail on the side of a platform where the
step will be installed.
When a step is installed on the 5' side of a platform, center the step on the platform and use
upper loops on both sides of the step. When installed on wider platforms, place the step to one
side of the platform and use a upper loop only on the side closest to the platform angle post
and use a closure on the other side. For placement in any other location on a platform, custom
components may be required.
Leveling feet come with the system. When adjusting the step, be mindful of applicable building
codes and ADA guidelines. EZ-ACCESS will not be responsible for any costs or liabilities resulting
from use of the leveling feet. The ground must be leveled at the proper height with respect to
the platform.
1.2. There are three common configurations for step use (FIG. 1.1). For situations other than those
shown, consult the project drawings for the specific arrangement.
1.2.1. Adjacent to ramp at 90° (an "inside" corner turn).
1.2.2. In-line on the opposite side of a ramp.
1.2.3. On a landing platform without a ramp (standalone).
Installation Supplement for PATHWAY® HD Steps
The platform to which the step attaches to must be stable and level.
The surface on which the step rests must also be stable and level. If ground is not stable
and level, create a surface that is stable and level at the proper height by digging or filling.
Never place a step directly across from a down sloping ramp without a gate or
other device to prevent the person descending the ramp from unintentionally
continuing forward down the steps.
FIG. 1.1
Page 5 of 29