Advertisement
Once connected to the switch CLI, the IP address can be set as shown by the example
below.
Example Configuration
>
>enable
#configure terminal
(config)#interface vlan 1
(config-intf-vlan 1)#ip address 10.19.221.50 /24
(config-intf-vlan 1)#no shutdown
(config-intf-vlan 1)#exit
(config)#exit
#write
Building configuration...
Done. Success!
#
C
CLI C
OMMON
The following are common CLI commands and tips for getting started with the CLI.
■
ntering a question mark (?) shows contextual help and options. For example, entering ? at
E
the prompt will show all commands available from that prompt.
■ To view interface statistics, enter show interface <interface type> <interface number>.
■ To view the current configuration, enter show running-config.
■ To view all the IP Addresses currently configured, enter show ip interface brief.
■ To view the AOS version, serial number, and other information, enter show version.
■ To save the current configuration, enter write.
P
OWER OVER
The NetVanta 1550-24P (P/N 17101524PF1) and the NetVanta 1550-48P (P/N 17101548PF1)
are Power over Ethernet (PoE) switches. PoE switches provide the ability to detect attached
powered devices (PDs) and deliver 48 VDC to the PD via existing Ethernet cabling. The
NetVanta 1550 PoE Series are fully compliant with the IEEE 802.3af and IEEE 802.3at PoE+
standards. By default, the PoE switches discover and provide power to IEEE-compliant PDs.
To disable PoE, use the power inline never command in the CLI. To disable power detection and
supply from the GUI, select the Ports page. Then select a port from the list (e.g., giga-swx 0/1).
This will bring up the port detail page for giga-swx 0/1. On this page, there is a check box to
disable power detection.
C
ONFIGURE THE
g
NOTE
The configuration parameters used in the examples outlined in this document are for instructional
purposes only. Please replace all underlined entries (example) with your specific parameters to
configure your application.
The following steps create an IP address and subnet mask for the VLAN interface vlan 1. If you
are not sure what IP address to assign, please contact your network administrator.
1. At the # prompt, enter config terminal.
2. At the (config)# prompt, enter interface vlan 1 to access the configuration parameters for
the VLAN interface.
2
OMMANDS
E
THERNET
U
'
IP A
NIT
S
DDRESS
617101524F1-13B
Advertisement
