Advertisement
Low frequency response
(AC coupling, -3dB)
DC gain accuracy
DC measurement accuracy
(average sampling mode)
Voltage difference (rV)
measurement accuracy
(average sampling mode)
Trigger sensitivity
Trigger level range
Trigger level accuracy
(Typical) applied on signals
of ≥20ns rise or fall time
Trigger capability
Holdoff range
Set level to 50% (Typical)
Edge type
Trigger mode
Pulse width
When vertical sensitivity is 2mV/div ±4% (sample or average
When vertical sensitivity is 5mV/div~5V/div ± 3% (sample or
average sampling mode)
When vertical position is zero and N≥16:
±(5%x reading+0.1div+1mV) and 2mV/div is selected;
±(3%x reading+0.1div+1mV) and 5mV/div is selected.
When vertical position is not zero and N≥16:
±(3%x(reading+vertical shift reading) +(1%xvertical shift
reading)+ 0.2div) Set from 5mV/div to 200mV/div plus 2mV;
Setup value >200mV/div to 20V/div plus 50mV.
Under identical setup and environmental conditions, the voltage
difference (rV) between two points of the waveform after the
average of ≥16 waveforms acquired waveforms is taken:
±(3% x reading + 0.05 div)
Trigger
Internal trigger 1 div
Internal
EXT
EXT/5
Internal
EXT
EXT/5
Normal mode/scanning mode, pre-trigger/delayed trigger
Pre-trigger depth is adjustable
Input signal frequency ≥50Hz
Edge Trigger
Pulse Trigger
(Less than, greater than or equal) positive pulse;
(Less than, greater than or equal) negative pulse
29
≤10Hz at BNC
sampling mode)
External trigger 100mV
±8 div from the centre of the
± (0.3 div x V/div) within ± 4 div
(from the centre of the screen)
± (6% default value + 40mV)
± (6% default value + 200mV)
96,000ns - 1.5s
Rise, Fall, Rise & Fall
20ns - 10ns
screen
±800mV
±4.0V
Advertisement
