Powercom 1000 User Manual page 13

To turn UPS on and off,
refer to Button Operation
Button operation
Cold Start function
When the main power is disconnected from UPS, it is capable of starting with
battery power for users' needs. Simply start the UPS as the instruction below.
Note: To avoid accidental battery discharge, cold start function is not available
until the initial connection to the main power.
1. "ON/OFF" button
Press and hold the "
(a)
Press and hold the "
(b)
working,
2. "Status/Enter" button
Use this button to check the content and confirm the selection of UPS.
Press and hold "
(a)
Display each status by pressing once. There are 10 statuses available for users.
(b)
Enter function only uses during settings. Check the" " button for more detail.
(c)
If UPS idles for 20 seconds, the display will return to the main status.
(d)
3. "Settings or Selection" button
Use this button and "ENTER" button to execute the setting
Press and hold the " " button for 1 second to enter the configurations of UPS.
(a)
Display each setting by pressing the " " once. There are 7 settings available for
(b)
users.
Press the " " button to enter the function.
(c)
Press the " " button to select your option.
(d)
Press the " " button to confirmation (YES/NO) of your selected option.
(e)
Press the " " button again to confirm and enable your function.
(f)
If UPS is idle over 10 seconds, the display will return to the main status.
(g)
© All rights reserved. All trademarks are property of their respective owners.
ON/OFF Button
To check UPS status and confirm settings, refer to Button Operation
" button for 3 seconds to turn on the UPS.
" button for 3 seconds to turn off the UPS while UPS is
" button for 1 second to check UPS contents.
Button Display
Function Button
12
Status / Enter Button
To check UPS status and confirm
settings, refer to Button Operation