Changing Parameter Settings Using Simatic Pdm - Siemens SITRANS F Series Operating Instructions Manual

8. During the process a progress bar is visible.
9. At the end of the zero adjustment, the outcome is displayed as an offset and a standard
deviation.
Note
If you get an error message after the zero point adjustment, refer to Device status symbols
(Page 95).
The system is now ready for normal operation.
6.2.8

Changing parameter settings using SIMATIC PDM

Note
Clicking on Cancel during an upload from device to SIMATIC PDM will result in some
parameters NOT being updated.
Many parameters are accessed via the online menus in SIMATIC PDM, see Parameters
accessed via drop-down menus (Page 66) for the others.
1. Launch SIMATIC PDM, connect to the appropriate device and upload data.
2. Adjust parameter values in the parameter value field then click on Enter. The status fields
read Changed.
3. Open the Device menu, click on Download to device, then use File → Save to save settings
offline. The status fields are cleared.
See also
Modbus addressing model (Page 135)
SITRANS FC310
Operating Instructions, 01/2019, A5E44036384-AB
Commissioning
6.2 Remote commissioning with PDM
65