Security Codes & Authority Levels; About Security Codes; Authority Level Definitions - ADT Security Manager 3000 User Manual

Your system lets you assign up to 45 different security codes for use by other users.
Only the Master user or Partition Programmer can assign user codes to users.
Users are identified by 2-digit user numbers 03-49 and are pre-assigned to
either partition 1 or partition 2 (users 01-02 are reserved).
Only the Installer or Master can change the partitions to which a user is assigned.
In addition to a security code, each user is assigned various system attributes.
User codes can be used interchangeably within a partition when performing
system functions (a system armed with one user's code can be disarmed by
another user's code), with the exception of the guest code described below.
User code programming involves these steps:
- First, choose a user number from the set of users assigned to the partition in
which the user will be operating, and assign a 4-digit security code.
- Second, assign an authorty level to that user.
- Lastly, assign other attributes as necessary (see attributes on the next page).
Authority levels define the system functions a particular user can/cannot perform.
Authority level categories are as follows:
Level Title
user Master
02
(0) Standard:
User
(1) Arm Only:
(2) Guest:
(3) Duress Code: Intended for use when you are forced to disarm or arm the
(4) Partition
Programmer user codes to users in their partition.
– 28 –
Explanation
Can perform all system functions and assign codes in both
partitions; can change its own code as follows:
Master code + [8] + 02 + new master code + new master code again
Can only perform security functions in assigned partition.
Cannot perform other system functions.
Can only arm the system. Cannot disarm or do other functions.
Can arm the system in assigned partitions, but cannot disarm
the system unless the system was armed with this code. This
code is typically assigned to someone (such as a babysitter or
cleaner) who has a need to arm/disarm the system only at
certain times. The user of this code should not use the "Quick
Arming" feature.
system under threat. When used, the system will act normally,
but can silently notify the Customer Care Center of your
situation, if that service has been provided.
Can do everything a standard user can do, and can assign