Arming Commands - ADT Security Manager 3000 User Manual

Before arming, close all perimeter doors and windows and make sure the Ready to Arm
message is displayed.
Mode Press these keys...
Stay security code + [3] (STAY)
Night-Stay security code + [3] + [3]
Instant security code + [7] (INSTANT)
Away security code + [2] (AWAY)
Quick Arming
If "Quick Arming" was programmed by the installer, the
place of the security code when arming the system. However, the security code
must always be used to disarm the system.
Function Key Arming
For any arming command, a function key may have also been programmed for your system. If
so, you can press and hold the appropriate function key for 2 seconds to arm the system. See
your installer for the designated functions (see Single Button Arming section).
Refer to the Accessing Other Partitions section for information on multi-partiion
arming.
Touchpad Confirms By...
three beeps
armed STAY message displayed
red ARMED indicator lights
three beeps
NIGHT-STAY message displayed
red ARMED indicator lights
three beeps
armed STAY message displayed
red ARMED indicator lights
Note that entry delay is turned off.
beeping for duration of exit delay
armed AWAY message displayed
red ARMED indicator lights
Leave the premises through an entry/exit
door during the exit delay period to avoid
causing an alarm. The touchpad beeps
rapidly during the last 5 seconds of the
exit delay to warn you that it is ending.
key can be pressed in
[#]
– 15 –