Burglary Protection; Security Codes; Fire Protection; Alarms - ADT Safewatch Pro 2000 User Manual

SYSTEM OVERVIEW (Continued)
Your system provides three modes of burglary protection: STAY, AWAY, and INSTANT, and
Burglary
Protection allows you to BYPASS selected zones while leaving the rest of the system armed. You must
turn on or "arm" the burglary protection portion of your system before it will sense burglary
alarms. The system also provides a CHIME mode, for alerting users to the opening of protected
doors and windows while the system is disarmed. Refer to the other sections of this manual for
procedures for using these features.
The following table lists the four different arming modes and the results of each.

Security Codes

At the time of installation, you were assigned a personal four-digit security code, known only to
you. You must enter the security code when arming and disarming the system, and when
performing other system functions. As an additional safety feature, other users who do not have
a need to know your code can be assigned different security codes. Refer to the SECURITY
CODES section for procedures on adding security codes to the system.
The fire protection portion of your security system (if used) is always active and will sound an

Fire Protection

alarm if a fire condition is detected. A key on the touchpad will enable you to manually initiate a
fire alarm, if necessary. Refer to the FIRE ALARM SYSTEM section for important information
concerning fire protection, smoke detectors and planning emergency exit routes.

Alarms

When an alarm occurs, both the touchpad and external sounders will sound, and the touchpad
will display the zone(s) causing the alarm. If your system is connected to a Customer Care
Center, an alarm message will also be sent. To stop the alarm sounding, simply disarm the
system.
A r m i n g
Mode Exit Delay
AWAY Yes
STAY Yes
INSTANT Yes
– 5 –
Features For Each Arming Mode
Entry Delay Perimeter Armed
Yes Yes
Yes Yes
No Yes
Interior Armed
Yes
No
No