ADT Security Manager 3000 User Manual page 47
Adt safewatch pro 3000 security manager 3000 security system user's guide
Hide thumbs
Also See for Security Manager 3000:
- Installaton manual (88 pages) ,
- Battery replacement instructions (4 pages) ,
- Programming manual (16 pages)
Table of Contents
Advertisement
SOUND
CAUSE
LOUD,
FIRE ALARM.
INTERRUPTED*
Touchpad & Ext.
LOUD,
BURGLARY/AUDIBLE
CONTINUOUS*
EMERGENCY ALARM.
Touchpad & Ext.
ONE SHORT BEEP
a. SYSTEM DISARM.
(not repeated)
b. SYSTEM ARMING ATTEMPT
Touchpad only
c. BYPASS VERIFY.
ONE SHORT BEEP
a. SYSTEM IS IN TEST MODE.
(once every 40 secs)
b, LOW BATTERY AT A
Touchpad only
TWO SHORT BEEPS
ARM AWAY.
Touchpad only
THREE SHORT
a. ARM STAY, NIGHT-STAY,
BEEPS
OR INSTANT.
Touchpad only
b. ZONE OPENED WHILE
RAPID BEEPING
a. TROUBLE.
Touchpad only
b. MEMORY OF ALARM.
c. SYSTEM LOW BATTERY.
d. EXT. SOUNDER WIRE FAIL.
SLOW BEEPING
a. EXIT DELAY WARNING
Touchpad only
b. ENTRY DELAY WARNING.
* If a bell is used as external sounder, fire alarm is pulsed ring; burglary/audible emergency is steady
ring.
WITH AN OPEN ZONE.
TRANSMITTER.
SYSTEM IS DISARMED.
(if programmed).
DISPLAY
FIRE is displayed; descriptor of zone in alarm is
displayed. If a fire alarm is manually activated, zone
number 95 will be displayed.
ALARM is displayed. If programmed, descriptor of
zone in alarm is also displayed
a. DISARMED/READY TO ARM is displayed.
b. Number and descriptor of open protection zone is
displayed.
c. Numbers and descriptors of the bypassed zones
are displayed (One beep is heard for each
zone displayed). Subsequently, the following is
displayed: DISARMED BYPASS /Ready to Arm.
a. Opened Zone identifications will appear.
b. LO BAT displayed with description of transmitter.
ARMED AWAY displayed. Red ARMED indicator
lit.
a. ARMED STAY or ARMED INSTANT displayed.
Red ARMED indicator lit.
b. CHIME displayed, descriptor of open protection
zone will be displayed if the [ ] key is pressed.
a. CHECK displayed. Descriptor of troubled
protection zone is displayed.
b. FIRE or ALARM is displayed; descriptor of zone
in alarm is displayed.
c. SYSTEM LO BAT displayed.
d. BELL FAILURE is displayed.
a. ARMED AWAY is displayed along with You May
Exit Now.
b. DISARM SYSTEM OR ALARM WILL OCCUR
is displayed. Exceeding the delay time without
disarming causes an alarm.
– 47 –
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Security Manager 3000 and is the answer not in the manual?
Questions and answers
How do I disarm with code?
To disarm the ADT Security Manager 3000, enter the security code on the touchpad. This will silence both the touchpad and external sounders if an alarm is active.
This answer is automatically generated