Scheduling; About Scheduling; Creating Schedules - ADT Security Manager 3000 User Manual

The system provides up to 16 end-user schedules (programmable by master/installer
only), which can be used to control various types of events.
Each schedule causes a defined event to start and stop (when appropriate) at a
specified time.
Schedules can be set to automatically repeat at various intervals.
Schedules can be set for random starting, if desired.
+ [#] + [6] [4]
1.
(Master Code)
2. Enter a 2-digit schedule number from 01-16.
Press [ ] to continue.
3. Enter the desired 2-digit event number from the
following list.
00 = clear the scheduled event
01 = turn a programmed output on or off
(see Using Device Commands section for a list of output device numbers used
in your system)
02 = set a user access schedule for one or more users
(see Security Codes section for an explanation of access groups)
03 = send a "latch-key" report to a pager if the system is not disarmed by a specified
time; message sent is "777-7777."
04 = automatically arm the system in STAY mode at a specified time (pager report
also sent)
05 = automatically arm the system in AWAY mode at a specified time (pager report
also sent)
06 = automatically disarm the system at a specified time (pager report also sent)
07 = Display the word "REMINDER" at a specified time
Press [ ] to continue.
4. For event number "01," enter the output number
associated with this schedule.
Otherwise, this prompt is skipped.
Press [ ] to continue to the "Start" prompt below.
=
– 33 –