Paging Feature; About Automatic Paging - ADT Security Manager 3000 User Manual

Your system may be set up to automatically send alert messages to a pager as certain
conditions occur in your system.
The following events can be programmed by your installer to send a message to
up to four pagers: arming, disarming, alarms, and trouble conditions.
You can also program the system to send an automatic pager message to alert
you in the event that someone has not arrived home (disarmed the system)
within a defined period of time (see the Scheduling section for details on
programming a "latch key report").
Your installer programs the pager phone numbers and reporting events.
The pager message consists of a 7-digit system status code that indicates the
type of condition that has occurred.
An optional, predefined 16-digit character string can precede the 7-digit system
status code; these characters can consist of a PIN no., subscriber account no., or
any additional data that you may wish to have sent to the pager.
The pager display format is as follows:
Optional 16 digits
A =
Optional 16-digits for
Account numbers,
PIN numbers, or any
other data;
programmed by the
installer, if required.
The 3-digit Event Codes (BBB) that can be displayed are:
911 =
Alarms.
The 4-digit number
(CCCC) following this
code is the zone number
that has caused the
alarm.
Examples of typical 7-digit pager displays follow.
Ex. 1
.
Ex. 2.
– 26 –
Æ Æ
AAAAAAAAAAAAAAAA – BBB – CCCC
B =
A 3-digit code that
describes the event
that has occurred
in your system
(see for event
codes table below)
811 =
Troubles.
The 4-digit number
(CCCC) following this
code is the zone number
that has caused the
trouble.
= Reporting of an alarm (911) caused by a fault on zone 4 (0004).
= Reporting of a closing–system arming (102)– by user 5 (0005).
È È
3-digit Event Code
A 4-digit User or Zone number, depending on the type of
event that has occurred, where:
alarms and troubles display zone number
arming/disarming (opens/closes) display user number
The first 2 digits are always "00" (e.g., 0004 represents
zone or user number 4), and, single-digit user or zone
numbers are always preceded by a zero.
101 =
Open
(system disarmed).
The 4-digit number
(CCCC) that follows
this code is the user
number that has
disarmed the system.
Å Å
4-digit User or Zone No.
C =
102 =
Close
(system armed).
The 4-digit number
(CCCC) that follows
this code is the user
number that has armed
the system.