Security Codes; To Assign, Change, Or Delete User Codes; Duress Code - ADT SAFEWATCH PRO User Manual

General
To Assign, Change, or
Delete User Codes
It is recommended that
obvious codes such as
1-1-1-1 or 1-2-3-4 not be
assigned.
Temporary users should
not be shown how to use
any system function that
they do not need to know
(e.g., how to bypass
protection zones).

Duress Code

SECURITY CODES

At the time of installation, your installer programmed a personal four-digit Master code,
known only to you and yours. This code is used to perform most system functions,
including arming and disarming of the system. As an additional safety feature, temporary
User Codes can be assigned for use by those not having a need to know the Master
code. Note: The Master code remains in effect even when other user codes are assigned.
IMPORTANT! When performing any of the procedures that follow, do not
allow more than 10 seconds to elapse between steps, otherwise the entry
will be aborted, and the procedure must be repeated from its beginning.
The Master security code can be used to assign up to 5 secondary User codes. It can also
be used to change any User code or to remove (delete) any User code from the system.
To Assign or Change a User Code:
1. Enter your Master code and press the CODE [8] key.
2. Enter the single-digit User Number for whom a code is to be assigned or
changed. (User Nos. 3 to 7 may be assigned.)
3. Enter the desired 4-digit code for use by that User Number. The touchpad will
beep once when a User code has been successfully entered.
Example: To assign a User code to user number 3, key the following:
+ 8 + 3 +
MASTER CODE
To Delete a User Code:
Perform steps 1 and 2 above and then stop. In a few moments, the touchpad will beep
once, indicating that the existing code has been deleted.
This feature is intended for use when you are forced to disarm or arm the system under
threat. When used, the system will act normally, but can silently notify the Customer Care
Center of your situation, if that service has been provided.
The Duress code may be any unused 4-digit code assigned to User Number 8.
– 10 –
DESIRED 4-DIGIT USER CODE
.