2N Helios Vario Installation Manual page 55

Buttons Substitution
This function is an analogy to memories in comfortable telephone sets. After two digits
ranging between 01 and 54 (0 may not be omitted) are pressed, the call to the
pre-programmed number is made. You can use
separate buttons, which saves buying the extender units and space on the installations
wall. The ideal solution is to use a few standard buttons for the most important speed
dialling options e.g. Warden, Reception and then provide a list of pre-programmed
options via the optional info panel that can be purchased.
Admissible Keypad Function Combinations
All of the above mentioned 4 functions can be combined freely – each of them can be
enabled or disabled separately as desired.
Keypad Operation Instructions – Summary
Door opening – code lock
Switch 2 activation:
Traditional button telephone
DTMF transmission during outgoing call (of a single button, not in the
telephone mode!)
Buttons substitution:
®
2N TELEKOMUNIKACE a.s., www.2n.cz
Enter any valid password for switch 1 and
Warning! Password 00 may not be used!
Enter any valid password for switch 2 and
Warning! Password 11 may not be used!
®
gets 2N Helios
Dials a number.
Transmits into tone dialling during pulse dialling.
Transmits a character in tone dialling.
Hangs up anytime during a call.
– tone-dials a number.
– The character is sent normally.
– The character is sent normally.
01...54 – the number that complies with the selected button (memory) is
dialled after a timeout.
– If an asterisk is pressed after number 01...54, the number is dialled
immediately unless it is identical with the set password.
®
2N
ready to dial a number.
Helios as if it had up to 54
.
.
55