2N Helios Vario Installation Manual page 22

16. Insert the printed foil labels.
17. Put the inserts back in the name plates.
18. Replace the name plates, clicking them into position. The name plates hold the
matt foil inserted underneath.
19. Check whether a silicone seal is inserted in the top groove of the plastic cover. A
spare seal package is included.
20. Close the metal cover and fix it with screws.
Outdoor Installation Rules
Always connect button backlighting – it is used for heating.
The joint between the roof module and the wall must be filled with a waterproof
cement to prevent water in-leak (see Figure 2.5).
Water must not leak in along or around the cables.
Warning
Name Tag Material and Printing
Each 2N
the printed foil into pieces and insert the labels in the name plates. Do not use paper to
avoid water in-leak and paper damage.
Red arrows are printed on the name plate. Make sure that the text and the arrow do
not overlap. We recommend you to use a template (MS Word) available at
or printing.
Flush Mounting
Follow the installation instructions included in the flush mounting box delivery.
Caution
®
2N TELEKOMUNIKACE a.s., www.2n.cz
Make sure that all the holes are filled with a waterproof material – top,
around the cables and screws – and that a side sealing is ensured.
®
Helios package includes a sheet of transparent foil for laser printing. Cut
The warranty shall not apply to product failures and defects caused by
improper installation (contrary to these instructions). The manufacturer is
neither liable for damages caused by theft within an area that is
accessible after the attached electric lock is switched. The product is not
designed as a burglar protection device except when used in combination
with a standard lock, which has the security function.
www.2n.cz f
22