TP-Link Pharos Series User Manual page 86

Go to the
following parameters.
Enable
Target Network
IP
Netmask
Gateway IP
Click Save and click Apply , then click Save .
4.8
Note:
Bandwidth Control submenu is only available in AP Router Mode and AP Client Router (WISP Client)
Mode.
Bandwidth control function is used to control the internet bandwidth in the local area
network. In the case of insufficient bandwidth resources, enable the function to make the
device allocate reasonable bandwidth to the clients and achieve the purpose of efficient
use of the existing bandwidth. Via IP bandwidth control function, set the upper and lower
limit in the bandwidth of the computer network and guarantee a smooth sharing network.
page. In the
Enable or disable the desired entry.
Enter the Target Network IP, the address of the network or host to be
visited. The IP address cannot be on the same network segment with the
device's WAN or LAN port.
Specify the netmask for the desired entry.
Enter the Gateway IP, the address of the gateway that allows for contact
between the Device and the network or host
82
section, click Add and specify the