Start Welding - Linde BOC Smootharc TIG200 DC Operating Manual

9. Stop Current
11. Spot Welding Time
13. Pulse Base Current
7.6

Start welding

Begin welding in either HF or LIFT TIG mode.
HF: Keep 2-4mm distance between the tungsten and the work piece.
Press the torch switch to start welding.
LIFT: Touch the tungsten to the workpiece. Press the torch switch to start
welding. There may be a delay to the arc initiation depending on
your pre-gas setting.
When welding stops (trigger is released) hold your torch postion over
the weld pool to allow a good finish.
BOC Smootharc TIG 200 DC Operating Manual
10. Post-gas Time
12. Pulse Frequency
14. Pulse Width
37