Table of Contents
Advertisement
FIGURE 4
WHEN DONE
Check Fluid Level. Replace lost fluid in system until full. To purge air, start engine, run for two seconds and shut
off engine. Check fluid level again. Add fluid until full. Do this until system stays full. Run truck for three minutes
or until fluid looses aeration. After system has been filled, turn wheels from lock to lock position (completely
right and left) five times. This will aid in bleeding out any air that may still be in the system. If the hand control
unit is working backwards, simply reverse the connections at the solenoids (switch the white and black wire on
the solenoid valve). See Figure 4. Make sure that you hear a slight "hiss" when the hand controller is pressed
"out" when the vehicle is running.
WARNING
•Winch cable must be wound onto the drum under a load of at least 500 lbs or
outer wraps will draw into the inner wraps and damage the winch cable.
Page 6
Advertisement
Table of Contents
