Table of Contents
Advertisement
5.2 Introduction to Application
In this subsection, we will show you the application menu layout and basic controls.
The application is divided into three menu levels. The first screen upon start includes
Configuration / Parameter / Basic (see the figure below), which displays all of the three
menu levels. The horizontal Main menu (Configuration) helps you select whether to
®
configure the 2N
Lift1
system or record new voice menus. The vertical menus
(Parameters) help you select the area to be administered. The third menu level, if
meaningful, gets displayed horizontally to the right and includes a list of parameter
setting forms.
®
Figure: 2N
Lift1 Service Tool
Window
The main menu contains three pop-up menus. The
Device
menu helps you connect to
or disconnect from the
CU
. Select the language mutation in the
Language
menu: CZ
and EN are available so far. The Help menu provides a link to the latest manual version
and information on the supplier. You will always be warned before logout or quit
against potential data loss.
You will also be warned against data loss before loading a new configuration and
overwriting the current set of parameters. Confirm your intention to avoid unintentional
loss of unsaved parameters.
Note
The language change will not be executed until the application restart.
The Status line displays the following information, from the left: Connected to includes
the name of the port to which you are currently connected corresponding with your PC
®
COM port. FW version specifies the current
2N
Lift1
audio unit FW version and Serial
®
number gives the
2N
Lift1
audio unit serial number. The logout button is situated in
64
®
2N
TELEKOMUNIKACE a.s., www.2n.cz
Advertisement
Table of Contents
