Lift1 Programming - 2N Lift1 User Manual

3.1 2N® Lift1 Programming
Before You Start
Make sure that programming is enabled (jumper) and that your phone supports
tone dialling.
Complete all the values to be modified into a pre-prepared form, which provides
a clear table of basic functions.
If your 2N
password and, if you are not completely sure of your 2N
execute full initialisation (Warning: The service password will also be initialised!).
Access to Programming Mode
You can only enter the programming mode during an incoming call (from a phone to
®
2N Lift1
(remember to enter an asterisk in front of and behind the password!). If the password
is correct and programming is enabled (jumper),
and displays a Help according to the context. The default password is
are recommended to enter a different password to protect your device against
unauthorised persons.
Tip
Programming Procedure
Having entered the programming mode, you can change any programmable value(s) in
any order. Proceed as follows: enter the parameter number and value. Use an asterisk
as a separator or Enter. In general, the function has the following format:
The parameter number has three digits (see the table). After you enter the number
and an asterisk, 2N
range of the parameter to be programmed. After you enter the value and another
asterisk, 2N
beyond the allowed range.
®
2N TELEKOMUNIKACE a.s., www.2n.cz
®
Lift1 is not brand new, make sure that you have the correct service
). Enter the access password:
"You have entered the programming mode"
If you forget your service password, contact the manufacturer to avoid
data loss.
While entering the password, keep a timeout of 5 seconds (or any other
value in the range between 1 and 9) for each character to avoid 2N
Lift1 hang-up and password/function re-entering.
parameter number
®
Lift1 reports the number/name, current value and potential
®
Lift1 announces "New value stored", or "Invalid value" if the value is
service password
®
2N Lift1
value
®
Lift1 configuration,
announces:
12345 and you
®
36