R
M
I
(I
)
ACK
OUNT
NSTALLATION
F APPLICABLE
2" min
LXL-0054
Figure 2–3 Cooling Fan Clearance
Removing the Skin and Installing the Top Cover
The skin is held in place by four screws at the rear panel of the LoaderXpress.
Users that purchase the LoaderXpress as rack mount ready (top cover installed) may skip
this section and proceed to
"Installing the LoaderXpress in the
Rack".
1) Remove the four screws, slide the skin cover about one inch toward the rear, then
lift it from the chassis. Save the hardware for re-use.
2-4
Installation