Functional Description; Extent Of The Delivery; Assembling Instructions - Grizzly ERT 530 R Original Instructions For Use

GB
12 Motor head
13 Chassis
14 Protective cover
15 Cutter head with line spool or
cutting thread
16 Spacing bow (flower protection)
17 Castor roll
18 Cord cutter
19 Nut for chassis mounting and
height adjustment

Functional description

The portable, hand-guided lawn trimmer is
powered by an electric motor. The trimmer
features a dual line spool as the cutting
device.
For grass trimming there are two nylon
threads rotating parallel with the ground
or, for vertical edge trimming, roughly per-
pendicular to the ground.
An additional chassis facilitates edge trim-
ming. A hood covering the cutting device
protects the user.
The following describes the functions of
the operating parts.

Extent of the delivery

Carefully unpack the trimmer and check
that it is complete:
• Lawn trimmer
• Protective cover with
1 cover mounting screw and
3 screws for mounting the castor roll
• Castor roll
• Additional handle
• Chassis
• Instruction Manual
84

Assembling instructions

Always disconnect the plug be- Always disconnect the plug be-
fore working on the trimmer and
wait until the cutting lines have
completely stopped. There is the
danger of electric shock and the
possibility of injury by the cutting
lines.
Use OEM parts only and mind
the thread cutter during assem-
bly. Risk of injury!
B
Assembling the protection
cover:
1. Put on the safety cover (14),
making sure to match the two
triangular marks.
Check that the cutting threads
are not caught.
2. Use the longer screw from the
package to secure the cover.
3. Use the three screws from the
package to to mount the castor
roll (17) to the bottom of the sa-
fety cover.
C
Mounting the additional handle:
1. Pull the ends of the auxiliary
handle (5) to extend the handle
and slide it over the handle rod
discs (20).
2. Screw down the auxiliary handle.
D
To mount the chassis:
The chassis attaches to the tele-
scopic shaft.
1. To extend the telescopic shaft,
loosen the threaded bush (9),
push or pull the shaft (10) to the
desired length, and tighten the
threaded bush again.
2. Place the chassis (13) on the te-