Lengthening The Cutting Lines; Working Instructions - Grizzly ERT 530 R Original Instructions For Use

GB
To adjust the handle rod:
The handle rod turns by 90° and 180° (see
chapter: „Working Instructions")
„
Pull down the lever (8) and turn the
handle rod (7) until it snaps into the
desired position.
To adjust the chassis:
The chassis is vertically adjustable to set
the cutting height as appropriate. If the
grass is very long or if you are trimming
edges, you can also fold away the chassis.
…
Loosen the nut (19) on the chassis
(13) and move the chassis along the
telescopic shaft (10). Tighten the nut.
Adjusting the spacing bow
(flower protection):
The spacing bow keeps plants and stalks
that are not to be cut away from the cut-
ting lines. If you do not need the spacer
bow, you can place it behind the castor roll
(parking position).
†
Tip the spacer bow (16) forward into its
working position.

Lengthening the cutting lines

A short or worn string will make
bad cuts. If you notice reduced cut-
ting performance, you should the-
refore check if there is still enough
string on the spool. Pull the power
plug first! Spool replacement is
detailed in section „Replacing the
Trimming Assembly".
Fully automatic dual line system
The equipment features a fully automatic
dual line system.
The lines will automatically elongate every
86
time you turn on the appliance. To support
proper line elongation, ensure that the coil
has stopped moving completely before
turning on the appliance again.
If the lines should be longer that defined
by the cutting circle then they will be au-
tomatically cut to the correct length by the
line cutter
Regularly check the nylon lines for
damage and whether the lines still
have the correct length defined by
the line cutter
When no line ends are visible:
• Renew the line spool (see Cleaning
and maintenance"„Replacing the trim-
ming assembly").
Adjusting the line length manually:
• Disconnect the plug from the mains
socket!
Press and hold the stop button (see
21) at the cutter head (15) and pull both
threads outwards

Working Instructions

WARNING. Danger of injury!
• Do not cut moist or wet grass.
• Before starting the trimmer check
that the cutting head will not
come into contact with stones,
rubble or other foreign bodies.
• Switch on the trimmer before you
approach the grass that is to be
cut.
• Always trail the extension cable
behind you. Do not pass the ope-
rating trimmer over the extension
cable as the cable could be da-
maged.
• Do not overload the trimmer duri-
ng operation.